IEC 60417-5140 RF equipment marked with Symbol IEC 60417-5140 for non-ionizing radiation.
This symbol means this is a Type B Applied Part.
This symbol means Attention: Consult Accompanying Documents (User Instructions)
The SR1 is: Internally Powered Equipment.
A Type B Applied Part Rated for Short Time Operation.
Recommended Operating Conditions
(A) Ambient temperature range of +10 C to +40 C
(B) A relative humidity range of 30% to 75%
(C) An atmospheric pressure range of 700 hPa to 1,060 hPa
Compliance Summary
The SomniResonance Device is a stand-alone technology. It is not part of a medical system. There are no accessories or connector cables for this device.
The SomniResonance Device may affect the normal function of sensitive medical electrical equipment. Do not wear the Device in any area where medical diagnostic or treatment devices are in use.
Do not store the SomniResonance Device on or near a microwave or any electrical or electromagnetic devices. Do not leave the Device on or near any heat producing surfaces or in a wet or moist area such as a bathroom.
Table 1: Manufacturers Declaration: Electromagnetic Emissions
The SR 1 is intended for use in the electromagnetic environment specified below. The customer or the user of the SR 1 should assume that it is used in such an environment.
Table 2: Manufacturers Declaration: Electromagnetic Immunity
The SR 1 is intended for use in the electromagnetic environment specified below. The customer or the user of the SR 1 should assume that it is used in such an environment.
Table 3: Manufacturers Declaration: Electromagnetic Immunity
The SR 1 is intended for use in the electromagnetic environment specified below. The customer or the user of the SR 1 should assume that it is used in such an environment.
Table 4: Recommended separation distances between portable and mobile RF communications equipment and the SR 1.
The SR 1 is intended for use in the electromagnetic environment in which radiated RF disturbances are controlled. The user of SR 1 can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the SR 1 as recommended below according to the maximum output power of the communication equipment.
